Geeetech

When following these instructions

https://dev.qu.tu-berlin.de/projects/sf ... i/Tutorial


When Calibrating the gyro sensor returns nothing



I have tried using a 3.3 v FTDI breakout board and i changed the jumper in the back to see if it will respond. IT does not.

I also notice that this board is using the ITG3205 and the tutorial is using ITG3200.

But i cant find differences in Address. I have also tried a I2C Address scanner found on arduino

http://playground.arduino.cc/Main/I2cScanner

with no luck.

Hi friend

Please try to use 5V FTDI breakout and test the sensors individually according to the wiki page http://www.geeetech.com/wiki/index.php/Product. ITG3205 is no

different to ITG3200.

Regards,
techsupport

I am using a 3.3v breakout and i jumped the back breaker to 5 and i tested it.


I get the same result after i changed the jumper

What about the sensor ADXL345, ITG3205, HMC5883L when you test them individually according to the wiki page?