Z axis limited to 100
Posted: Wed Dec 25, 2019 10:47 pm
Hi Everyone,
in my Geetech I3 alu, i never printed object taller than 100mm
When i try this morning, i see a limit a 100mm.
when i try to move more than 100 directly on" move panel" in printer, i can't go .
anyone now what setting i need to move to push the limit to 180?
It's a soft limit because when i change the step ratio, i can go to 180mm physicaly but under 100 in command.
in my Geetech I3 alu, i never printed object taller than 100mm
When i try this morning, i see a limit a 100mm.
when i try to move more than 100 directly on" move panel" in printer, i can't go .
anyone now what setting i need to move to push the limit to 180?
It's a soft limit because when i change the step ratio, i can go to 180mm physicaly but under 100 in command.