Page 1 of 1
M201 and 3DTouch.
Posted: Sat May 11, 2019 6:12 am
by Bs2000
Did anyone find out if the z-min connections work and get source code for the M201 so we can add 3dtouch
Re: M201 and 3DTouch.
Posted: Sat May 11, 2019 5:38 pm
by _kaktus_
Hi.
When I was a new M201 user, I thought just like you. I wanted to have an automatic levelling device.
Today I think it's a superfluous gadget.
Of course, if someone wants to have it, I won't advise against it.
It is possible that when our printer will have a redesigned Firmware, it will be possible to add such a peripheral.
Unfortunately, this is not the case today.
Re: M201 and 3DTouch.
Posted: Sun May 12, 2019 11:10 pm
by Bs2000
How do you know they are going to redesign the firmware? They told me a few days ago that they have suspended updates to the M201 because of new models.
Re: M201 and 3DTouch.
Posted: Mon May 13, 2019 12:46 am
by _kaktus_
Hi.
You can't take it literally.
A new version of the branded firmware is simply created, that can be adapted to our model.
Re: M201 and 3DTouch.
Posted: Mon May 13, 2019 8:48 am
by Bs2000
Well I sure hope so seeing I had just purchased this machine and for the amount of money I paid I would have went with a newer model if I know all this beforehand
Re: M201 and 3DTouch.
Posted: Mon May 13, 2019 12:34 pm
by _kaktus_
HI.
Oh, yeah, right.
Don't worry.
This is a very good DIY model.
I would have chosen it again.
But the fact is that the price has risen recently.
Re: M201 and 3DTouch.
Posted: Wed Dec 22, 2021 8:29 pm
by Bs2000
Has this yet to be figured out? here we are 4 yrs later and still so limited with the m201