Another edition of the M201 printer firmware for the GTM32Pro vB controller board.

[_kaktus_]

Hi all.


I will not wait any longer and give the users another version of the firmware for our printer model.

I was supposed to make the firmware available only after thorough testing. However, there is still no time.
So I release it earlier. Unfortunately, I am not able to say what changes have been made. The team that was responsible for the development for a long time no longer works for GT. I hope that more than just the version number label has changed.
What I want and what I want for you.
.

gtm32_machine_m201_V1.0.04.zip

(62.24 KiB) Downloaded 902 times

I've uploaded the firmware to my printer. It was also done by my friend from France (algernon).
The printers are still working.
.

firmware1-0-04.jpg (343.75 KiB) Viewed 25686 times

.
Once you have uploaded the new firmware, don't forget to enter the used settings again. Then it is worth to save them in the memory of the controller.

[William]

Thanks for your feedback.

[_kaktus_]

[Bs2000]

so this firmware is from 2019, im sure it is out of testing. How is it working and what changes are there?