Geeetech

Here you can share you great ideas about hardware innovation. Here you can enjoy more professional and specialized services, Here is a platform for you to make a difference!
http://geeetech.net/forum/

Problem with Geeetech A30: Z Axis is 2-3mm above the bed at the start of the print!

http://geeetech.net/forum/viewtopic.php?f=76&t=71105

Page 1 of 1

Re: Problem with Geeetech A30: Z Axis is 2-3mm above the bed at the start of the print!

Posted: Thu Aug 20, 2020 3:59 pm
by William
Did you level the hot bed after auto home? If still not resolved, you can refer to the video settings below. :D
https://www.youtube.com/watch?v=tOxUrP2wOjA

Re: Problem with Geeetech A30: Z Axis is 2-3mm above the bed at the start of the print!

Posted: Sat Aug 14, 2021 2:17 pm
by RaveMO
thank you very much!
All times are UTC+08:00
Page 1 of 1
Powered by phpBB® Forum Software © phpBB Limited
https://www.phpbb.com/