Factory default

novawaves · Post by **novawaves** » Mon Mar 30, 2020 1:44 am

Please tell me how i can set everything to factory defaults, i think i used an unknown g code and changed the quality false so that the z axis dont work right now. Plesse tell me the parameters of the factory defaults variables or tell me how i can define them in the firmware

Thx

Post by **William** » Mon Mar 30, 2020 10:57 am

Hi, You can perform recovery operation through the screen
Or update the firmware again.

novawaves · Post by **novawaves** » Mon Mar 30, 2020 10:21 pm

ok thats what i have done , a firmware flash but the problem with my z axis is still there

Post by **William** » Tue Mar 31, 2020 10:24 am

novawaves wrote: ↑
Mon Mar 30, 2020 10:21 pm
ok thats what i have done , a firmware flash but the problem with my z axis is still there

Hi, Is the z-axis motor not working properly?
You can exchange the other motor end wires with the z-axis motor wires.
Check if the motor cable is damaged.

Geeetech

Factory default

Factory default

Re: Factory default

Re: Factory default

Re: Factory default