Re: Rostock 301 can't printing--
Posted: Wed Nov 14, 2018 9:26 am
You need to post in the correct section.barker wrote: ↑Wed Nov 14, 2018 4:17 amHello.
I am new to this forum and unfortunate owner of a 301 Mix for 2 months and ... no printing
I'm struggling with Geetech because my first problem is this:
All the connectors are well connected, I heat the nozzle to 200 ° C and then no extruder does not want to turn to drive the wire.
I think their cabling has a problem but I do not understand anything
For information, when I disconnect the engine E0 (the one with the termistor etc) and I reconnect it, I feel that the engine "is loading" while it should not
At voltmeter, the red wire with the blue is at -12 V, the black with the blue is at +12 V.
Do you have an idea ? because geetech, even more worth trying to contact them they are 0 !!!
Thank you.
________________________________________________________________________________________________
I'm moving it.