Page 1 of 1
rostock 301
Posted: Sun Jun 03, 2018 3:41 pm
by spc111111
how do i adjust the motor voltage
Re: rostock 301
Posted: Mon Jun 04, 2018 11:32 pm
by orest
Look at this picture from another post.
download/file.php?id=1512&sid=ed25eedb5 ... 9b1f1f594f
You will need to adjust the potentiometer which is the silver colored, screw with a cross in it. It is labeled with a +. You will need a voltmeter.
Re: rostock 301
Posted: Tue Jun 05, 2018 6:22 pm
by Admin
spc111111 wrote: ↑Sun Jun 03, 2018 3:41 pm
how do i adjust the motor voltage
Hi,
Welcome to Geeetech world.
You can easily search lots of message from this forum.
Make full use of search function, sometimes you might get the answer immediately.
Re: rostock 301
Posted: Wed Jun 06, 2018 10:23 am
by spc111111
thank you very easy to do, i thought it would be a software item, i will give this a try. do you think this will get them to run in the correct direction? every time i have tried to run it the head just shoots to the plate.
Re: rostock 301
Posted: Wed Jun 06, 2018 2:24 pm
by spc111111
okay, i now have all my pots running at 1.1v all my motors are running in the correct direction, but i think i got some bad linear bearings. reason i think this, they do not glide smoothly like the rest of my other printers. they all feel like they might be scoring the riser shafts, how can i get this problem taken care of?