Cura profile needed for minis (A10M)
Posted: Mon Dec 07, 2020 12:14 pm
Hi,
I have been trying to configure my A10M to print minis, but it has been very difficult since I am new at this.
I get lots of stringing and sometimes my layers aren't closing properly. Can anyone that prints miniatures share their profile so I can have a (better) starting point? JI am really lost.
Thanks.
I use a A10M and my slicing software is Cura 4.8
I have been trying to configure my A10M to print minis, but it has been very difficult since I am new at this.
I get lots of stringing and sometimes my layers aren't closing properly. Can anyone that prints miniatures share their profile so I can have a (better) starting point? JI am really lost.
Thanks.
I use a A10M and my slicing software is Cura 4.8