Wanted A30T Start GCode for printing
Posted: Mon Jul 20, 2020 12:28 am
Hi,
I bought the A30T, and I do no like how it starts the warm up process 2-3mm in the center of the print bed,
how or what can I add/modify to the g-code to make it do this in the safe position off the front of the bed?
Edit..
Actually I have a few requests that I would like to have.. if possible...
So 1st was the safe warmup position.
2nd would be a move to atleast 1/2 max zheight and perform a print purge cycle, e0 for XXmm E1 for XXmm, E2 for XXmm.. then perhaps back to whichever I have selected for the 1st layer do purge again.. or just do it in reverse to e0 .. either way, not automatic, just need the code to add to perform this task.
Thanks
I bought the A30T, and I do no like how it starts the warm up process 2-3mm in the center of the print bed,
how or what can I add/modify to the g-code to make it do this in the safe position off the front of the bed?
Edit..
Actually I have a few requests that I would like to have.. if possible...
So 1st was the safe warmup position.
2nd would be a move to atleast 1/2 max zheight and perform a print purge cycle, e0 for XXmm E1 for XXmm, E2 for XXmm.. then perhaps back to whichever I have selected for the 1st layer do purge again.. or just do it in reverse to e0 .. either way, not automatic, just need the code to add to perform this task.
Thanks