Geeetech

Hello,
I have a printer geeetech prusa i3 pro w I would like to import it in Cura software but I can't get the profile, could you give me some directions ? thank you very much.

Hi, you can download this configuration file.

Hi ! I've downloaded in Cura 4.6.1. and that's not working on my Geeetech Prusa I3 Pro W, the printer is with 1 extruder and no G-Code to begin and ending the print.

didibxl wrote: ↑

Wed Jun 10, 2020 12:47 am

Hi ! I've downloaded in Cura 4.6.1. and that's not working on my Geeetech Prusa I3 Pro W, the printer is with 1 extruder and no G-Code to begin and ending the print.

Hi，this is Cura's configuration file, about some parameter settings

Hi,

I have tried to import the cure profile but I get a warning saying that the file does not contain any valid profile. I have tried to import it from settings-> printer-> manage printers -> profiles-> import. Any ideas on how I can configure the cure profile for Geeetech prusa i3 pro w printer?

I have a GeeeTech i3 pro w and I downloaded the "resources" file and tried to apply it to cura 4.8 but nothing happened and it said "Cannot load (Definitions) file please try again later." I need a step by step explanation and some help because I currently cannot print without these files.

These are the only parameters I had to change (apart from choosing Prusa i3 as a machine on the James Armstrong's profile photo So some of these values are in direct conflict with what is listed in the Cura document that came with the I3. navyarmyccu