Profiles for Repetier Host / Slic3r for A20M?

[JimAero]

Thanks for the profile. I like using a raft, and I added 1mm thickness to all sides. Works great! Really appreciate it!

[JimAero]

I am using the Slic3r profile from Tomyuan, but Repetier only shows 1 Extruder. The menu in Slic3r shows 2 extruders. Any help would be welcome.

Thanks!

[harris1379]

Hi Vert,
I guess, the only possible solution is to remove these disks.
E-Steps changed to 422 (Calibration done), ...
mywegmansconnect

No new result depending the stringing.

IMG_20190512_153329.jpg

ya sir we did try other things but its not working

[remboroy]

Does the extruder working temperature achieve Preset temperature？

Hello William,
I don't have a thermometer, therefore, I didn't check this. The Dog was printed with 205°C:



This looks very good, I think.

See Discussion here: http://www.geeetech.com/forum/viewtopic ... 08&t=68468 mywegmansconnect.club

Thanks,
Moritz

Great information
Thanks for sahring

[leasehold_s]

If you want to calibrate your estep.
Refer to this vid：
https://www.youtube.com/watch?v=X3A9Ir2SreI

My estep is 457

Great Thanks for sharing
very useful information
lease extension calculator