how to install malin on i3 Pro B?

[Diplomator]

Hi,

i bought me also a Geeetech i3 Pro B Acryl installed a BL Touch and i wanna upgrade the software for the BL touch. but it dont work ..
i downloaded the firmware open the Marlin.ino in Arduino, choose Com Port 6 and Board Arduino Mega or Mega 2560 and update the printer,
it says

Sketch uses 138930 bytes (54%) of program storage space. Maximum is 253952 bytes.
Global variables use 4393 bytes (53%) of dynamic memory, leaving 3799 bytes for local variables. Maximum is 8192 bytes.

but on the printer himself is no change and is shows on the Sceen under about

PI3 Pro B
SW Vers:1.0.05
SN.........

any idea what i make wrong ?

[Admin]

Hello, if you want to install the firmware, please refer to the link below:
http://www.geeetech.com/forum/viewtopic ... 20&t=17046

[joseph8475]

Download the Marlin-Development,mygiftcardsite zip archive by clicking the Download ZIP button. Unzip it into a folder of your choosing. Now download Arduino IDE for setting up and uploading the firmware to your 3D printer.