Geeetech

hello, I started having this problem yesterday after two weeks of pringint.

Basically anything I print will only print on the right side of the heatbed. Anything on the left the extruder will move and draw the object but the extruder stops extruding and gets back to normal once it moves to the right side.

photo is supposed to be a cross for example

Hi!

Sounds bad bed leveling, at left side the nozzle is touching bed/glass and don´t extrude plastic, try to level again. With vibration it´s normal, I level every week or two weeks, depending how much I print.

Best regards.