Retraction Problem, extruder go away!
Posted: Sun Jun 21, 2020 6:17 am
Hi all!!
During printing, between one hour and two hours of printing. the extruder goes out of the model, a few times per layer. more than 6 centimeters without any need.
As it moves, it retracts filament. causing it to cool in the extruder and block everything.
I don't know what to do, it does it with almost all models. I am using Cura.
Any solution? Someone else happens?
During printing, between one hour and two hours of printing. the extruder goes out of the model, a few times per layer. more than 6 centimeters without any need.
As it moves, it retracts filament. causing it to cool in the extruder and block everything.
I don't know what to do, it does it with almost all models. I am using Cura.
Any solution? Someone else happens?