3d Touch GT 2560 Rev A
Posted: Sun May 31, 2020 1:43 am
Hi i recently purchased a 3d Touch sensor for my I3 Pro B with GT 2560 Rev A.
During the installation i stuck at this part:
Step1. Remove the Z max connector from the board and replace it with a 3Pin Straight Pin. You need to use soldering iron here.
I don't have any way to do it.
Is there's any other way to install the 3d touch without removing this connector??
Thank you.
During the installation i stuck at this part:
Step1. Remove the Z max connector from the board and replace it with a 3Pin Straight Pin. You need to use soldering iron here.
I don't have any way to do it.
Is there's any other way to install the 3d touch without removing this connector??
Thank you.