Bed adhesion problem
-
DjBurner20
- Posts: 3
- Joined: Fri Apr 24, 2020 11:30 pm
Bed adhesion problem
Hi there, I have a newly built Prusa i3 Pro B and I’m having real problems with bed adhesion, using 1.75mm filament with 0.3mm nozzle, 200c on extruder and 60c on the bed, have tried using clean glass, masking tape, hairspray, glue stick, adding a skirt raft and brim everything but the print breaks away from the glass after only a couple of layers, any suggestions
Re: Bed adhesion problem
Hi，if your bed is clean and flat, it is recommended that you increase the temperature of the first layer to enhance adhesion.
-Keep your mind and try to test it. 
-Everything will be fun！-Support all Getech printer.
-You can ask me the questions and I will kindly reply.
-Respect others is the best way you can get help!
-Everything will be fun！-Support all Getech printer.
-You can ask me the questions and I will kindly reply.
-Respect others is the best way you can get help!
Re: Bed adhesion problem
You are running .3 nozzle that does not put out much plastic you must have minimum nozzle /bed clearance
and then try running 200% extrusion on first layer. This makes the 1st layer thicker, neater and it sticks much better.
regards moorebrm
and then try running 200% extrusion on first layer. This makes the 1st layer thicker, neater and it sticks much better.
regards moorebrm