Z axis motors moving in opposite direction to each other!!!
Posted: Fri Oct 11, 2019 7:43 pm
Hi guys,
Just in the process of setting up the printer, ive got to the stage the test the homing positions and have encountered a problem.
Ive tried searching, but having seen any posts on my issue.
When using Repetier, connecting to the printer and commencing the manual home, the x and y axis work fine. They hit the end stop and the test progresses to the next motor test. The last stage, the z axis motors turn in the opposite direction to each other. Left side is .reverse phone lookupnba reddit pcpartpicker
When adjusting the firmware (True/false) this just switches the issue, left side goes down and right side goes up.
Is this just a simple wiring issue? have I plugged into the wrong point on the board? The board is GT2560
Thanks in advance for any help and advice anyone can offer
Just in the process of setting up the printer, ive got to the stage the test the homing positions and have encountered a problem.
Ive tried searching, but having seen any posts on my issue.
When using Repetier, connecting to the printer and commencing the manual home, the x and y axis work fine. They hit the end stop and the test progresses to the next motor test. The last stage, the z axis motors turn in the opposite direction to each other. Left side is .reverse phone lookupnba reddit pcpartpicker
When adjusting the firmware (True/false) this just switches the issue, left side goes down and right side goes up.
Is this just a simple wiring issue? have I plugged into the wrong point on the board? The board is GT2560
Thanks in advance for any help and advice anyone can offer