Geeetech

Hey,
I'm onwner of the standard Prusa I3 dual. I would like to change my Printer into the M201 Version.
I'm looking for the Alu-Hotend-mount plate (cyclops dual hotend) and for the GTM32 Board with software.

Perhaps I can still use my GT2560 Board and only change the software ??
Target should be, to ba able mixing colors etc like the M201 software allows it!
I've not many experiences in flashing softwares, dont want to break something. The Prusa I3 is printing very well so far. Just want to make it better

Regards

Huyen

Hi, the M201 board is GTM32 Pro VB.

Hello huyenvu111


In my opinion, your goal can be achieved with an existing version of the controller.
Of course, some accessories will need to be replaced.
I suggest that you start your project by finding the firmware in the required version for your controller board.