Geeetech

Hello together,

I just assembled my new printer and got some trouble with the x axis not moving. I already tried some things on it:
- Switching to the y axis control on the mainboard, it is moveable through y axis movement, but the y axis controlled by x axis is not moving (so motor is not defect)
- Switched the cable, no affect (so cable is working)
- Changed the driver thingis on the board, doesn't help at all, the x axis slot isn't working

Don't know what to do, please help...

Best regards
Pasweb

Hi, You mean to swap the motor line of the x-axis to the motor of the other axis.
Is the motor also running?

There is no problem with the x-axis motor and motor line.
Then you need to replace the motherboard, there is a problem with the x-axis motor slot.

Hello.


It is worthwhile to try to improve the soldering pads of the socket.

Maybe there is a cold solder there It is worth to improve the contacts with the hot soldering tip of the soldering iron.

Yes, Motor is okay an the cable to the motor also.
That's unlucky, how do I get a new board?

Also I recognized the problem with the z axis not moving properly, maybe I got a monday model?

Hi.


You can describe your problems to your dealer, the controller board should be replaced with a working one.

PasWeb wrote: ↑

Sat Aug 17, 2019 9:41 pm

Yes, Motor is okay an the cable to the motor also.
That's unlucky, how do I get a new board?

Also I recognized the problem with the z axis not moving properly, maybe I got a monday model?

Hi, You can contact your sales to replace it.