My X axis motor does not go to the limit switch

[szymko0703]

Prusa I3 pro B is my first 3D printer. Everything works well in addition to the x-axis engine. Going back home, this engine spins to the right, and the limit is on the left.


I am asking for help in solving the problem. Thank you all.

[William]

Does the motor go to the right while controlling the x-axis to the left?
If yes, it always goes the wrong way, it may be a problem with the firmware.you can change the direction in the firmware. http://www.geeetech.com/forum/viewtopic ... 20&t=17046
If not, the X motor only goes in one direction no matter how you control, it may be a problem with the motor. please test the endstop.viewtopic.php?f=17&t=60927

[szymko0703]

Hi
The motor when zeroing goes in the opposite direction. I know that I can change this in the software by changing true to false or vice versa. I do not know if I should change it to true or false. Can you somehow check how is it set now?

[William]

You can try changing the true to false, false to true, and then debugging.