Page 1 of 1
Irregular Extrusion
Posted: Thu Apr 04, 2019 12:03 am
by apastor
Hello I have a Geeetech I3 Pro B a year ago.
I have been printing for months with PLA 1.75 with no problem. But 2 days ago suddenly began to print as shown the attached photo.
- IMG_20190403_135543.jpg (432.88 KiB) Viewed 4872 times
I have cleaned the extruder with the rod several times without success.
What I can do?
Re: Irregular Extrusion
Posted: Thu Apr 04, 2019 1:30 pm
by _kaktus_
Hello.
Have you tried to print the same but with a different filament?
Re: Irregular Extrusion
Posted: Thu Apr 04, 2019 2:46 pm
by apastor
I do not have another filament, I will buy another coil of different brand.
It is strange, because with this coil I have printed about 100gr without problem.
Thanks.
Re: Irregular Extrusion
Posted: Mon Apr 08, 2019 5:35 pm
by apastor
After trying another new filament I still have the same problem.
I think the extruder is not pushing the filament hard enough.
What things can I check to verify the correct operation of the extruder?
Greetings.
Re: Irregular Extrusion
Posted: Thu Apr 11, 2019 5:28 pm
by William