[Solved] BL touch initialising but not working

[Tparent]

Just discovered that GT2560 A+ were produced in different version (but still with the same release/name A+)

If you are upgrading your FW and are not able to operate your BL touch correctly (still initialising at power on but not reacting to any menu command), there is a high probability that you are encountering the same issue than me (pin inversion).

To solve, edit PINS_GT2560_A_PLUS and swap the two value ( replace 11 by 32 inside IF block and 32 by 11 inside elseif)

Hope it help

Thierry

[_kaktus_]

Hello Tparent.


This is a very valuable notice.

[Tparent]

Thanks