3D Touch Issues
Posted: Mon Dec 17, 2018 4:33 am
Hi,
I am having issues getting my 3D Touch to work with my Geeetech i3 Pro B, I have followed the documents and soldered the three pins on my GT2560 and connected up the cables.
I have used the Marlin 1.1.4 firmware with the 3DTouch settings changed and adjusted the X, Y, and Z.
When I power on the pin pops out twice and then the pin stays up and the red light is on NOT flashing.
When I issue a G28 command the extruder starts and moves down towards the bed but just keeps going and does not stop and I have to power off.
If I issue an M command nothing happens except M119 which returns open for X, Y & Z.
Also I have noticed that the Marlin firmware downloaded does not have a "pins_GT2560_REV_A.h" file is this correct?
Thanks for any help and support
Julian
I am having issues getting my 3D Touch to work with my Geeetech i3 Pro B, I have followed the documents and soldered the three pins on my GT2560 and connected up the cables.
I have used the Marlin 1.1.4 firmware with the 3DTouch settings changed and adjusted the X, Y, and Z.
When I power on the pin pops out twice and then the pin stays up and the red light is on NOT flashing.
When I issue a G28 command the extruder starts and moves down towards the bed but just keeps going and does not stop and I have to power off.
If I issue an M command nothing happens except M119 which returns open for X, Y & Z.
Also I have noticed that the Marlin firmware downloaded does not have a "pins_GT2560_REV_A.h" file is this correct?
Thanks for any help and support
Julian