Z axis goes too high

ManEatingSnail · Post by **ManEatingSnail** » Tue Nov 06, 2018 2:51 pm

Hi there,

I'm having some trouble with my new printer I've built. I have gone through the settings loads of times but can't see where I am going wrong. I have calibrated everything and it all looks fine to start with.

The printer will firstly print the first couple layers perfectly. I have had to adjust the z-offset to achieve this (-0.4) however after the first few layers the z axis will raise too high and then it just becomes a spaghetti murder scene. Can anyone give me any advise on how to overcome this?

Thanks

DjBurner20 · Post by **DjBurner20** » Fri Apr 24, 2020 11:31 pm

I have exactly the same problem with my newly built printer, is there a solution to this

Post by **William** » Sat Apr 25, 2020 10:37 am

Hi, can you provide a picture?

DjBurner20 · Post by **DjBurner20** » Fri May 01, 2020 4:38 am

I resolved this issue by changing the zsteps/mm to 400 solved that one

Geeetech

Z axis goes too high

Z axis goes too high

Re: Z axis goes too high

Re: Z axis goes too high

Re: Z axis goes too high