Geeetech

Hello all,
its going to be my 6th print and this one seems to be going really really slow. The estimated time in slicer is 9 hours but its been more than 24hours now and still printing. My previous print did not had any issues the estimated time was somewhat ok. I have not change any settings compared to other prints. The only difference is this one is higher. The speed printing is noticeable,the extruder is moving really really slow.

The settings am using is from the pdf for prusa i3b

Thanks for the help in advance

Hello.


Slicer allows you to release printing. The duration of the printout is also influenced by the filling.
Finally, in the printer menu you can slow down or speed up work. Even when the printer is running.

oh I did not know you could! I was scared to touch anything when it was printing I did not want to wait another day for printing the same thing lol

The pictures are the slicer settings and it's been showing 2h23min ete since this morning..

https://ufile.io/oyok1
The video of it printing..you will see how slow it is

hmm..i saw the problem..it was my fault the filament keep turning the knob thus decreasing the filament speed to 11% i set it to 30% its much better now..thanks for the tip on the speed..

Next time, take some more time to prepare photos so that you don't have to turn over the monitor.



˙ʇı op ʇ'uop ı ʇnq ,ʎɐʍ sıɥʇ ǝʇıɹʍ uɐɔ ı

˙ǝɯᴉʇ ǝǝɹɟ ɹnoʎ uᴉ ʇsod ƃuᴉʍolloɟ ǝɥʇ pɐǝɹ
viewtopic.php?f=77&t=60830#p84782