Geeetech

Hi guys, I'm a newbie and I would to know what I must do after assembling.
I suppose I must follow these steps:

1) Install Repetier-host.
2) Install firmware and drivers.
3) Calibrate axes.
4) Calibrate extruder.
5) Print my first piece.

Are these steps correct?
Where can I find tutorials to do them?

Hi

You presented everything perfectly.
I don't know if you know there is a wiki site for all Geeetech products. It also contains the instructions you need.
In addition, I expect Geeetech to provide links to this information when describing your favorite printer.

I believe you might find the sotution here https://www.the-essays.com/admission-essay because there are lots of samples and tutorials. I often fix my issues with their help.

_kaktus_ wrote: ↑

Wed Aug 15, 2018 4:17 pm

Hi

You presented everything perfectly.
I don't know if you know there is a wiki site for all Geeetech products. It also contains the instructions you need.
In addition, I expect Geeetech to provide links to this information when describing your favorite printer.

dgcustomerfirst

Thanks for the clarification

Thank you for updating us with the outcome.

Paycheckrecords