Page 1 of 1
Issues with new extruder
Posted: Thu Jul 05, 2018 5:13 am
by SoupersSB
So I recently bought a new extruder as my old one had a clogged hothead and a nut that couldn't be unscrewed so I bought a new extruder, I believe it was this: Redrex Assembled MK8 Extruder, which I was told by many, worked with a pro B. However upon purchasing, I have found that the wires that plug into the main board are completely different! Any ideas on a work around?
https://imgur.com/a/dhGV11K
Re: Issues with new extruder
Posted: Thu Jul 05, 2018 10:35 am
by Gingko
The slot of thermistor can fit the mainboard.
For the heating wiring, just remove the slot and wire it directly to the slot of mainboard.
Re: Issues with new extruder
Posted: Thu Jul 05, 2018 1:45 pm
by _kaktus_
Hi
If this plugin is a problem for you, you can always cut it off. If necessary, replace with another.
Re: Issues with new extruder
Posted: Thu Jul 05, 2018 2:28 pm
by _kaktus_
A very good solution has been found for my printer.
This is the ARK screw socket.
- listwa_ARK.png (120.63 KiB) Viewed 4868 times
This socket is very versatile and reliable.
And it does not pose any problems when it comes to replacing the connected periphery.
