I have hit and miss success. The first couple layers are mostly poor see pic, with gaps. I've leveled bed again before this print, checked nozzle seams to flow well. It seams to be in the same place each time any suggestions? I use hairspray on bed. Any help would be greatly appreciated. Thank you
First layers bad, with gaps.
First layers bad, with gaps.
Hi all.
I have hit and miss success. The first couple layers are mostly poor see pic, with gaps. I've leveled bed again before this print, checked nozzle seams to flow well. It seams to be in the same place each time any suggestions? I use hairspray on bed. Any help would be greatly appreciated. Thank you
![Image]()
<a href="https://ibb.co/jNYJUd"><img src="https://preview.ibb.co/nCJVaJ/IMG_20180612_194030.jpg" alt="IMG_20180612_194030" border="0"></a>
I have hit and miss success. The first couple layers are mostly poor see pic, with gaps. I've leveled bed again before this print, checked nozzle seams to flow well. It seams to be in the same place each time any suggestions? I use hairspray on bed. Any help would be greatly appreciated. Thank you
Re: First layers bad, with gaps.
The first layers should be printed much slower with increased filament delivery.
These settings are made in the slicer.
These settings are made in the slicer.
On the forum I help to use the rod, I don't give fish.
Geeetech Prusa I3 M201 Dual extruder Mixcolor 3D printer, bought 2017-12-19, already built, in the cognitive and improvement phase
Geeetech filament, ABS only
Geeetech 3D WiFi Module for 3D Printer, bought 2018-04-15, He got a new life, and still lies in a drawer.
Positively frenzied customer of Getech Technology.
Geeetech Prusa I3 M201 Dual extruder Mixcolor 3D printer, bought 2017-12-19, already built, in the cognitive and improvement phase
Geeetech filament, ABS only
Geeetech 3D WiFi Module for 3D Printer, bought 2018-04-15, He got a new life, and still lies in a drawer.
Positively frenzied customer of Getech Technology.
Re: First layers bad, with gaps.
I've tried re calibrating the extrusion as it was about 15 mm in 100 short but I keep getting different values, I've tried in the geeetech slicer and slic3r.
Re: First layers bad, with gaps.
1, What's your driver voltage of extruder?
2, Maybe the nozzle clogged a little, try to clean it.
3, Increase temperature a little to have a test.