2nd extruder problem
Posted: Wed Apr 04, 2018 3:35 pm
Hi everrybody
I have a problem with my I3 pro b, added 2'nd extruder everything works fine except can not get the extruder motor to run
(hot end works fine) have tried different firmware including the one for Pro C,
I also have a Tevo Tarantula that I upgraded to dual extruders without any problems.
Anybody have any ideas what my problem could be?
Found the problem no power from extruder socket on gt2560, may have to check soldering.
Cheers preben
I have a problem with my I3 pro b, added 2'nd extruder everything works fine except can not get the extruder motor to run
(hot end works fine) have tried different firmware including the one for Pro C,
I also have a Tevo Tarantula that I upgraded to dual extruders without any problems.
Anybody have any ideas what my problem could be?
Found the problem no power from extruder socket on gt2560, may have to check soldering.
Cheers preben