Geeetech

hello, I installed correctly the sensor but the tilt tends to hang and activated the alarm (red flashing)
It hangs down, I try to go up or down the screw (magnet), it works but from time to time it still blocks, do you have any tips or a link to correctly configure the sensor screw please ?
thank you

I think you should refer to your 3dtouch user manual at first?

Nothing about this adjustement with the magnet screw on top of the sensor anywhere.
With chance, it happen not too much, but when arrive, i must enter the gcode for stop the alarm and adjust the screw, is it like the screw move itself when extrudor viber.