Page 1 of 1
3d Touch @ Delta Rostock GS2?
Posted: Mon Feb 12, 2018 5:55 am
by DerSchlangen
Hi!
It is posible to improve my delta Rostock GS2 with a 3D Touch probe?
Can you tell me the wiring? I did not have a 3 Pin Port on my board like in your wiki instruction.
And could it be that the used port is blocked by the endstop of the axis?
greetings...
Re: 3d Touch @ Delta Rostock GS2?
Posted: Mon Feb 12, 2018 11:00 am
by William
Yes, you can add it
You can refer to others who add 3d touch at the forum
Re: 3d Touch @ Delta Rostock GS2?
Posted: Tue Feb 13, 2018 4:21 am
by DerSchlangen
Can you please give some links?
Re: 3d Touch @ Delta Rostock GS2?
Posted: Tue Feb 13, 2018 3:40 pm
by William
Here are tips for GT2560A+ wiring
(You should ensure your mainboard is GT2560 or GT2560A+)
- GT2560A+.png (1.36 MiB) Viewed 8323 times
Re: 3d Touch @ Delta Rostock GS2?
Posted: Tue Feb 13, 2018 5:41 pm
by DerSchlangen
Hello and Thank u!
It is not the Rev A+ wich is build in at my Printer.
Can you please descripe the wiring for GT2560?
Re: 3d Touch @ Delta Rostock GS2?
Posted: Fri Feb 16, 2018 11:44 am
by William
Re: 3d Touch @ Delta Rostock GS2?
Posted: Sat Feb 17, 2018 5:28 am
by DerSchlangen
Hi!
There is a Problem in your instruction!
At the Delta Rostock G2S the Z-max connector is used for the z-max endstop. In your Instruction (maybe it is a prusa Printer?) they use z-max for 3D-touch.
Maybe i'am wrong but i can not use this pin otherwise there is a Problem in homeing the axis without z-max.
Do you have a instruction for Delta-Rostock Printer?
Re: 3d Touch @ Delta Rostock GS2?
Posted: Tue Feb 20, 2018 1:49 am
by DerSchlangen
No one a idea or a hint? Some instruction?
I did not understand Marlin in that kind of way to change on y-min contact.
Please help. Could Geeetech give some hint?