Geeetech

Hi out there,
i have a Problem with connecting my 3D Touch ABL-probe to my main control board.

In your instruction under
https://www.geeetech.com/wiki/index.php ... ing_Sensor
i find a Picture of the GT2560 wich did not look like my board!

My Board Looks like:
https://www.geeetech.com/wiki/index.php/GT2560

Now please can you translate me the wiring of the Auto bed leveling probe? I did not have a 3pin z-max contact on may board.

Please give me a short instruction how to wire the 3D Touch probe.

THX a lot

You should ensure your mainboard is GT2560 or GT2560A+
Wirings of 3d touch at this two type mainboard are not same

Can u please describe me how i can identify the typ of my board? I have a Delta Rostock mini GS2.

Where i can find the shematics to wiring the probe?

Please give me some advice.

Here is a pic of the mainboard of GT2560A+