Changing I3 Dual into M201 Version !?
Posted: Mon Jan 22, 2018 11:55 pm
Hey,
I'm onwner of the standard Prusa I3 dual. I would like to change my Printer into the M201 Version.
I'm looking for the Alu-Hotend-mount plate (cyclops dual hotend) and for the GTM32 Board with software.
Perhaps I can still use my GT2560 Board and only change the software ??
Target should be, to ba able mixing colors etc like the M201 software allows it!
I've not many experiences in flashing softwares, dont want to break something. The Prusa I3 is printing very well so far. Just want to make it better ;)
Regards Ben
I'm onwner of the standard Prusa I3 dual. I would like to change my Printer into the M201 Version.
I'm looking for the Alu-Hotend-mount plate (cyclops dual hotend) and for the GTM32 Board with software.
Perhaps I can still use my GT2560 Board and only change the software ??
Target should be, to ba able mixing colors etc like the M201 software allows it!
I've not many experiences in flashing softwares, dont want to break something. The Prusa I3 is printing very well so far. Just want to make it better ;)
Regards Ben