Geeetech

helloo,

almost get the printer ready to print, but there's one issue.

if i try to offset the Concave Convex of the bed nothing happens

(For each 1.0 unit increase or reduce of the DELTA_RADIUS, the z printing volume
will increase or reduce 0.2 unit)
#define DELTA_RADIUS
(DELTA_SMOOTH_ROD_OFFSET-DELTA_EFFECTOR_OFFSET-DELTA_CARRIAGE_OFFSET+1）

the nozzle touch the bed at 0.3 z, so i thought i set it to 0 but nothing happens

any of you a idea of what i could be ????????

i upload it with Arduino 1.0.6

Greetssss from Holland :D

Maybe you should check the configuration.h in these lines

You should ensure Z-offset value is under this range

Hi

I check the settings, it was too high
Both are 25

But if i change the settings, must i repeats the steps for calibration?

You should set the value to -5 to 15 and recalibrate

heej

i change the settings to -5 and 15 and recalibrate the printer

still nothing happens :( tryed different values.

the nozzle is still at the same high by z: 0

about 2mm from the bed

Still trying to get the concafe offset but nothings happens
I have no ideaa what to do :'(

You can increase the range of Z max

Must i change the z high only in the program( repetier host ) or also in the software???

Gr
Skymen

Both are needed

Finally succeed to calibrate the printer correctly. The next problem is that the motor on the top ( dont know the name of it. Xd) stop pressing the filament to the hotend.

There is nothing comming out the nozzle. Only when i pressed the filament with my hand down to the motor it wil come out the nozzle :s