Geeetech

I have finaly finishing building my Rostock 301 3D Printer and am in the process of setting it to start my first print. following the Manual i have levelled the Hot bed and am now on the set up the slicer softeare.

It mentions loading a Rostock 301 PLA config .ini file.

Where do i find this also will i need to load a ABS config.ini file as well

I am going to try with ABS first

ABS is sensitive to temperature, so I do not recommend that you start your journey with ABS printing

Thank you, I have also bought some PLA so will take your advice and try thhat first.

Do you know where to find the Config file mentioned in the user manual.

Thanks

It is my own Rostock 301 config.ini

I think you can use Repetier-Host for slicing