Print problem - calibration????

[Exio]

Hi everyone,
I have a problem in 3d printing. As you can see in the picture, there is a breakdown in the layers on the x axis. Can someone help me?
Thank you

[William]

Hi, You can try 1. Check the belt tightness of each axis;
                     2. Check if the bearing and the pulley are issued (can be lubricated for lubrication);
                     3. Check the drive board voltage (0.8-1.2V);
                     4. Maybe the printing speed is too fast, so you can reduce the printing speed appropriately.
I hope this can help you.

[Exio]

Thanks William, I try and let you know. What is the correct belt tension? What is the correct tension?

[William]

Hi ,It can be said that it is not particularly tight enough to move, and it will not be loose and there is a big gap.
Like this；

The belt.jpg (164.32 KiB) Viewed 4531 times

[Exio]

Hello
I applied your advice and the printing is much improved. As you can see, there is still a small mistake. Can you give me some other advice?
Thank you

[William]

Hi, It still looks like an offset, maybe you still need to check the previous ones and print at a speed that is not too fast.