Been trying to find a fix for this for a while but I haven't found anything that helps, wondering if anyone has any advice. I'm an artist not an engineer so all of this is new grounds to me.
I have banding on my prints that match up to the threads on the rods, in both height and depth. I've tried adding some anti-wobble mods, they made no difference at all. What am I doing wrong?
Z banding from threaded rods?
Z banding from threaded rods?
- Attachments
-
- Capture.PNG (177.26 KiB) Viewed 3076 times
Re: Z banding from threaded rods?
How easy does your carriage move up/down (z direction)? Maybe it gets stuck a bit?
One image in the building instructions is wrong -- it shows that the rings on the x carriage rods should be on the "outside", but in fact they should be in the "inside", as to prevent the belt pulling the two sides together (and making it stuck).
One image in the building instructions is wrong -- it shows that the rings on the x carriage rods should be on the "outside", but in fact they should be in the "inside", as to prevent the belt pulling the two sides together (and making it stuck).