Issues with new extruder
Issues with new extruder
So I recently bought a new extruder as my old one had a clogged hothead and a nut that couldn't be unscrewed so I bought a new extruder, I believe it was this: Redrex Assembled MK8 Extruder, which I was told by many, worked with a pro B. However upon purchasing, I have found that the wires that plug into the main board are completely different! Any ideas on a work around? https://imgur.com/a/dhGV11K
Re: Issues with new extruder
The slot of thermistor can fit the mainboard.
For the heating wiring, just remove the slot and wire it directly to the slot of mainboard.
For the heating wiring, just remove the slot and wire it directly to the slot of mainboard.
Re: Issues with new extruder
Hi
If this plugin is a problem for you, you can always cut it off. If necessary, replace with another.
If this plugin is a problem for you, you can always cut it off. If necessary, replace with another.
On the forum I help to use the rod, I don't give fish.
Geeetech Prusa I3 M201 Dual extruder Mixcolor 3D printer, bought 2017-12-19, already built, in the cognitive and improvement phase
Geeetech filament, ABS only
Geeetech 3D WiFi Module for 3D Printer, bought 2018-04-15, He got a new life, and still lies in a drawer.
Positively frenzied customer of Getech Technology.
Geeetech Prusa I3 M201 Dual extruder Mixcolor 3D printer, bought 2017-12-19, already built, in the cognitive and improvement phase
Geeetech filament, ABS only
Geeetech 3D WiFi Module for 3D Printer, bought 2018-04-15, He got a new life, and still lies in a drawer.
Positively frenzied customer of Getech Technology.
Re: Issues with new extruder
A very good solution has been found for my printer.
This is the ARK screw socket.
- listwa_ARK.png (120.63 KiB) Viewed 4885 times
And it does not pose any problems when it comes to replacing the connected periphery.
On the forum I help to use the rod, I don't give fish.
Geeetech Prusa I3 M201 Dual extruder Mixcolor 3D printer, bought 2017-12-19, already built, in the cognitive and improvement phase
Geeetech filament, ABS only
Geeetech 3D WiFi Module for 3D Printer, bought 2018-04-15, He got a new life, and still lies in a drawer.
Positively frenzied customer of Getech Technology.
Geeetech Prusa I3 M201 Dual extruder Mixcolor 3D printer, bought 2017-12-19, already built, in the cognitive and improvement phase
Geeetech filament, ABS only
Geeetech 3D WiFi Module for 3D Printer, bought 2018-04-15, He got a new life, and still lies in a drawer.
Positively frenzied customer of Getech Technology.