Hi out there,
i have a Problem with connecting my 3D Touch ABL-probe to my main control board.
In your instruction under
https://www.geeetech.com/wiki/index.php ... ing_Sensor
i find a Picture of the GT2560 wich did not look like my board!
My Board Looks like:
https://www.geeetech.com/wiki/index.php/GT2560
Now please can you translate me the wiring of the Auto bed leveling probe? I did not have a 3pin z-max contact on may board.
Please give me a short instruction how to wire the 3D Touch probe.
THX a lot
Connecting 3D-Touch to GT2560
Re: Connecting 3D-Touch to GT2560
You should ensure your mainboard is GT2560 or GT2560A+
Wirings of 3d touch at this two type mainboard are not same
Wirings of 3d touch at this two type mainboard are not same
-Keep your mind and try to test it. 
-Everything will be fun！-Support all Getech printer.
-You can ask me the questions and I will kindly reply.
-Respect others is the best way you can get help!
-Everything will be fun！-Support all Getech printer.
-You can ask me the questions and I will kindly reply.
-Respect others is the best way you can get help!
-
DerSchlangen
- Posts: 0
- Joined: Mon Feb 12, 2018 5:27 am
Re: Connecting 3D-Touch to GT2560
Can u please describe me how i can identify the typ of my board? I have a Delta Rostock mini GS2.
Where i can find the shematics to wiring the probe?
Please give me some advice.
Where i can find the shematics to wiring the probe?
Please give me some advice.
Re: Connecting 3D-Touch to GT2560
Here is a pic of the mainboard of GT2560A+
- GT2560A+.png (1.36 MiB) Viewed 6931 times
-Keep your mind and try to test it.
-Everything will be fun！-Support all Getech printer.
-You can ask me the questions and I will kindly reply.
-Respect others is the best way you can get help!
-Everything will be fun！-Support all Getech printer.
-You can ask me the questions and I will kindly reply.
-Respect others is the best way you can get help!