Hi, recently assembled my printer and started check to all wires, heaters work etc. All seems to conected correct and working, lcd was also working fine but then I started to level my bed and by the end of this process I realised that lcd now is showing data only in left top corner (on the start up 2 stripes are seen on all lenght of lcd)
Is it faulty lcd, mb or software problem?
I3 Pro W display fault
Re: I3 Pro W display fault
1.You can try to restart your printer again
2.Check the cable of LCD install correct or not
3.Re-uploading the firmware
2.Check the cable of LCD install correct or not
3.Re-uploading the firmware
-Keep your mind and try to test it. 
-Everything will be fun！-Support all Getech printer.
-You can ask me the questions and I will kindly reply.
-Respect others is the best way you can get help!
-Everything will be fun！-Support all Getech printer.
-You can ask me the questions and I will kindly reply.
-Respect others is the best way you can get help!