Z axis not stepping correctly ?.

[jackyjoy123]

Hello,

I just finished assembly of my aluminium prusa I 3 and on my first test print x and y are perfect, but z never moved so I was just dumping pla all over and hit e-stop. I ran the print again without filament and noticed my z does eventually step, but much slower than it should. I have tinkered with the motor voltage with no https://creditcardsupportx.com/barnes-a ... mastercard
https://creditcardsupportx.com/pep-boys-credit-card https://creditcardsupportx.com/lord-and ... redit-card luck and almost think it may have something to do with slic3r settings or my firmware. Z works terrific in manual mode. Anyone have any ideas?


thanks
jackyjoy