Gt2560 board, switching hotend 1 with hotend 2 ?.

[jackyjoy123]

Hello,

I seem to have broken port one for my hotend in my geeetech prusa i3 pro b gt2560 board, the left side screw port is broken and lose, resulting in my hotend not heating up.
After searching online on if there is a fix I came across a forum which claims I can switch hotend/extruder port 1 with the other port beside it using the pin.h file in firmware.
https://krogerfeedback.nl https://talktosonic.onl https://talktowendys.vip https://whataburgersurvey.onl
Has anyone tried this as a quick fix un-till they received their new board. I will post an image with the firmware changes it says to make.

Do you think this could work?

thanks
jackyjoy