X and Y axis not homing after upgrade

[Antitesto]

Hi
Thanks for the reply Loboheat.

Didn't work!

I free the stepper motors, then move X to the far left and Y right back, I leave Z where it is.

When I send G28, X and Y move the there maximum and then tries to go further (loud jumping noise) and Z then comes down and touches the edge of the heat plate twice the stops.


Can I send G28 followed by G29, to see the probe pattern?

Cheers

ดูหนัง Netflix

[bigbbdriver]

Hi

Downloaded the files and Arduino 1.8.2, many thanks

Ver 2.0.6 won't compile, getting this error


Using library LiquidCrystal at version 1.0.5 in folder: F:\arduino-1.8.2\libraries\LiquidCrystal
fork/exec F:\arduino-1.8.2\hardware\tools\avr/bin/avr-gcc.exe: The filename or extension is too long.
Error compiling for board Arduino/Genuino Mega or Mega 2560.

[LoBoHEAT]

Hi!

Install the library LiquidCrystal and try again.

Best regards.