I'm new to 3d printing and have hit a bit of a snag while setting up.
I have built the printer and all the motors are running freely.
I have setup using Repetier Host as per the instructions. The issue I have is that only the Y axis moves to the stopper when I click the home button. The X and Z axis' move very slightly in the wrong direction. It's as if they don't know their home position.
Any help or advice would be appreciated.
I3 Pro B Initial Setup
Re: I3 Pro B Initial Setup
Hi,You can first check whether the wiring on the motherboard is correct;
Check whether the limit switch is installed correctly;
If the running direction of the motor is different from the expected direction, you may need to modify the running direction of the motor in the firmware. For specific operations, you can refer to: viewtopic.php?f=17&t= 17037
If the motor runs in only one direction, you can connect the printer to the manual control of the Repetier Host and enter M119 to view the limit switch. For details, you can refer to: http://geeetech.com/forum/viewtopic. php? f = 17 & t = 60927
Check whether the limit switch is installed correctly;
If the running direction of the motor is different from the expected direction, you may need to modify the running direction of the motor in the firmware. For specific operations, you can refer to: viewtopic.php?f=17&t= 17037
If the motor runs in only one direction, you can connect the printer to the manual control of the Repetier Host and enter M119 to view the limit switch. For details, you can refer to: http://geeetech.com/forum/viewtopic. php? f = 17 & t = 60927
-Keep your mind and try to test it.
-Everything will be fun!-Support all Getech printer.
-You can ask me the questions and I will kindly reply.
-Respect others is the best way you can get help!
-Everything will be fun!-Support all Getech printer.
-You can ask me the questions and I will kindly reply.
-Respect others is the best way you can get help!