Geeetech

Here you can share you great ideas about hardware innovation. Here you can enjoy more professional and specialized services, Here is a platform for you to make a difference!
http://geeetech.net/forum/

Filament issue

http://geeetech.net/forum/viewtopic.php?f=65&t=72606

Page 1 of 1

Filament issue

Posted: Sat Apr 24, 2021 2:33 am
by Kintalind69
I just got my A30 printer and the filament for my #0 stops feeding or doesnt feed at all constantly. I can see that the wheel is turning to push it through but it feels stuck. If start pushing it super hard it goes again. I tried adjusting the tension with the screw on the side but it doesnt seem to change anything.

Any ideas? This is really frustrating as it makes the printer useless.

Nozzle temp is right at 200C
Filament is geeetech brand PLA
All times are UTC+08:00
Page 1 of 1
Powered by phpBB® Forum Software © phpBB Limited
https://www.phpbb.com/