A30T
Posted: Sun Apr 11, 2021 3:03 pm
Hello,
I have a Geeetech A30T. As you can see on the picture, the printing is very good.
I have a question about the color mix software. It seems that the software "accepts" only two extruders: E0 and E2.
When I want to use 3 extruders, it comes to a error message "The setting for extruders is wrong", and than I have to swith to the 2 extruders modus.
Does anyone have a solution about this problem?
Thank you in advance for your help!
Stefan
I have a Geeetech A30T. As you can see on the picture, the printing is very good.
I have a question about the color mix software. It seems that the software "accepts" only two extruders: E0 and E2.
When I want to use 3 extruders, it comes to a error message "The setting for extruders is wrong", and than I have to swith to the 2 extruders modus.
Does anyone have a solution about this problem?
Thank you in advance for your help!
Stefan
- IMG-20210411-WA0000.jpeg (191.9 KiB) Viewed 2017 times
- IMG_20210403_073843.jpg (183.98 KiB) Viewed 2017 times