Geeetech

Here you can share you great ideas about hardware innovation. Here you can enjoy more professional and specialized services, Here is a platform for you to make a difference!
http://geeetech.net/forum/

Install 3D touch instead of capacitive proximity senso

http://geeetech.net/forum/viewtopic.php?f=65&t=71177

Page 1 of 1

Install 3D touch instead of capacitive proximity senso

Posted: Fri Sep 04, 2020 5:43 pm
by Ton
Hi,

I've been searching the forum to use 3D touch on A30 that has pre installed sensor slot for capacitive sensor but i want to use 3D touch.
Already installed 1.37.58 version of firmware. Also removed the male pins intended for the capacitive sensor and connected the 5 pins accordingly for the 3D touch instead. Take note that i did not use the 3 pin slot. I used the 5 pin slot.

Enabled the 3D touch mode and the auto leveling to let me test the installed 3D touch. But it doesn't work. Please can anyone help me.

Re: Install 3D touch instead of capacitive proximity senso

Posted: Mon Sep 07, 2020 4:42 pm
by William
Hello, you can check if there is an adapter board interface on your hot end, just connect 3d to the adapter board. :D
All times are UTC+08:00
Page 1 of 1
Powered by phpBB® Forum Software © phpBB Limited
https://www.phpbb.com/