A30 Swiss Micro Direct Extruder Hot End Combo
Posted: Mon May 25, 2020 10:32 pm
I finally got it up and running.
Dual part cooling fans were probably overkill but I prefer everything to be symetrical and not off balance.
I got my first satifactory calibration cube.
I kept having prints pop off the plates at different times during the print so I had to keep lowering part cooling. Ultimately I went with 40% part cooling slowly increasing from levels 2-7.
There is no doubt in my mind the upograde was worth it.
I am going to have to keep working on settings to get it dialed in.
Dual part cooling fans were probably overkill but I prefer everything to be symetrical and not off balance.
I got my first satifactory calibration cube.
I kept having prints pop off the plates at different times during the print so I had to keep lowering part cooling. Ultimately I went with 40% part cooling slowly increasing from levels 2-7.
There is no doubt in my mind the upograde was worth it.
I am going to have to keep working on settings to get it dialed in.
- 20200525_102148.jpg (208.62 KiB) Viewed 4771 times
- 20200525_102219.jpg (266.82 KiB) Viewed 4771 times