Micro Swiss Direct Drive Extruder and All Metal Hot End

[Barmac]

Well the kit came in early.
Shipping was about 2 days.
Here she is naked without any fans or cooling shrouds.
The fans will be coming this weekend and I will need to print a Cooling shroud with a 3d touch adapter. I also have to figure out how to connect the Hot End circuit board.
I won't recommend this kit yet but I was able to get it on my A30 with some modification. The X-axis belt was too tight. I had to reset the clamps on the belt And it was just barely long enough. Had I known I would have purchased a

20200423_105135.jpg (214.36 KiB) Viewed 4289 times

20200423_105210.jpg (269.41 KiB) Viewed 4289 times

belt and clamps.

20200423_105135.jpg (214.36 KiB) Viewed 4289 times

[William]

Hi，you can connect as shown：

3d touch 接法.png (398.84 KiB) Viewed 4282 times

DSC_3789.JPG (121.87 KiB) Viewed 4282 times

TIM图片20200415110654.png (124.54 KiB) Viewed 4282 times